Die Plate Generator — the complete die impression, built from several coins
1 · Specimens
Coins struck from the same die: your own photos plus lots from the auction archive. Two-sided lot photos are split — choose which face to take:
Auction archive 472,000 lots
Search by ruler, mint, type or catalogue number. Press +A / +B on a lot to add that face. Look-alikes uses the site's coin image index to find visually similar lots to your anchor coin.
2 · Align rotation · scale · shift
Each coin is matched to the ⭐ anchor on its relief (rotation sweep × scale × phase correlation). Score = how sharply the two reliefs lock together after alignment: > .60 same coin · ≥ .20 die link? · .08–.20 possible · < .08 weak. The bands are provisional — always confirm in the Overlay view, where matching strokes turn grey; the verdict is yours. Keep the rotation range as tight as the photos allow.
Fine-tune against the anchor (Overlay view)
3 · Composite
Best detail measures the struck relief in every small patch of every coin and lets the sharpest coin write that patch — a stroke worn off the anchor is taken from the coin where it survives, so the legend completes itself. Selectivity 1 blends, 6 hard-picks. Every specimen contributes only inside its own flan; Coverage shows how many coins support each area, Provenance which coin each patch came from.
3b · Assemble by hand paint from a coin
Pick a coin, then paint on the Composite view: that patch is taken from that coin. Peek blends the chosen coin in so you can see what it has to offer before painting. Auto paints a region back to the automatic choice.
4 · Plate
The plate carries the composite, coverage and provenance maps, the specimen strip and your note.
Add coins of one die to begin your photos, or lots from the auction archive · align · build · save the plate
Add coins of one die to begin.
About Die Plate Generator
Hand-struck coins — medieval European hammered pennies and groats, Islamic dirhams and dinars, Mughal and Sultanate rupees, princely-state issues, early colonial coinage — were struck on flans smaller than the die, so no single coin shows the whole design. The Die Plate Generator aligns several specimens struck from the same die, your own photographs or look-alike lots pulled from the CoinSchool auction archive, and composites the best-struck part of each into one complete impression of the die.
Alignment sweeps rotation and position in a die frame and ranks poses by normalised cross-correlation, so coins photographed at different sizes and angles still register. A best-detail compositor chooses the sharpest source for every region, a correction brush lets you override it, and the finished plate exports with coverage and provenance maps showing which coin supplied which part.
It is intended for die studies, catalogue plates and the reading of full legends and dates that are off-flan on every individual coin.
How to use Die Plate Generator
Add photos of coins you believe share a die, or pick archive look-alikes.
Let the tool align them and check the overlay and the match score.
Build the composite, correct any region with the brush.
Export the labelled plate with its coverage map.
Frequently asked questions
How do I know two coins share a die? Die-linked coins match in every detail of the legend layout, letter spacing and small flaws. The aligner’s correlation score and the blink overlay make such a match visible; a low score means different dies.
Does it work for Greek, Roman and medieval coins? Yes. Any series struck by hand from engraved dies — Greek, Roman, Celtic, Byzantine, Islamic, medieval European, Indian — can be aligned and composited. The archive look-alike search is strongest for Indian and Islamic coins.
Can I use coins from the auction archive? Yes. The tool suggests look-alike lots from the archive and loads their images as additional specimens.